Loading...
 
Skip to main content

Features / Usability


Forum security and privacy

Hi...again

Right I have scoured the literature and found several "articles" and read "tiki for dummies/smarties" relating to what I wish to do but none work so can anyone help please.

I have a group (call it group X) which I wish to give secure and private access to a particular forum. All members of the group must also have a registered status. Now I have 2 computers one running admin and the other running a registerd user who has not joined group X.

I make all the recomended permission changes global vs group vs category et al via my admin login but my registered user on a separate computer(but not a member of group X) can view/post/anything really to that forum which I was hoping would be only avaialble to group X.

So how to I make it such that a forum is only available to a certain group (group x) which has to been "joined" but those members joing the group are also registered users and have access to everything else on the site?


I promise I have tried everything in the sections I can find but always my registered unjoined group x user can basically do anything to the forum...please point me in the right direction.

Nick

PS I am very much a tiki newbie!!

It should work if, on the permissions page for that special forum, you assign tiki_p_forum_read to Group X. This actually means "Group X (and nobody else) can read this forum." Checking the Group X checkbox should remove the check marks from the anonymous and registered group checkboxes. (This is Tiki 6 I'm looking at.)

-- Gary

Thank you Gary for you help.

I finally seemed to get it working after resetting all permissions everywhere I could find on everything I was able to admin only then starting again...so many of them I suppose one odd one was set but I didn't see it.

Eventually it worked and as you said now denies access to 'unwanted' users.

Is there a global reset i.e. set tiki 6.1 back to its out of box setup. Learning all this has made the site a little messy as I cobble over mistake, inset bits of html here and there. So now I basically know what I am doing it might be worth sitting down, designing then input the setting from scratch?

These permission are a nightmare I have to say...

Thanks again
Nick